Table of Contents
Advertisement
Getting Started
Access Point Hardware Installation
Access Point Hardware Setup explains how to quickly setup the Access Point for
use via a wired Ethernet connection, and using the factory default settings. For
installation in networks using other than the default settings, i.e. into existing
networks, complete the Hardware Setup and refer to Using the AP COMFig Tool,
page 11. To setup a wireless station, refer to the PCI/PC Card User's Guide.
step1.
Connect the Ethernet network cable to the UTP port on the back panel
of the Access Point.
step2.
Connect the power adapter to the electricity outlet and then to the
Access Point DC-In port on the back panel of the access point.
The Access Point is now ready to communicate with the wireless stations using its
factory default settings. Refer to the InstantWave High Rate PCI/PC Card User's
Guide for card setup instructions.
LED Indicators
The Access Point LEDs show the status of the connections. Figure 5 shows the
LEDs and Figure 6 their functions.
8 InstantWave
High Rate 11Mbps Access Point
Figure 4. Access Point
Figure 5. Access Point LEDs
Advertisement
Table of Contents
