Table of Contents
Advertisement
Available languages
Available languages
adjusted. The speed c ontrol dial adjusts the rotation speed o fthe pad
from approx. 0 to3700 rpms.
TRIGGER SWITCH
As the trigger switch is pressed in, the rotation continues to increase,
but will not exceed the maximum setting on the speed control dial.
As the trigger is released, the sander head revolutions per minute are
reduced.
Proper
Hand
Position
(Fig. 7)
_WARNING:
To reduce the risk of serious personal injury, ALWAYS
use proper hand position as shown.
_WARNING:
To reduce the risk of
FIG.7
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper
hand position
requires one
hand under the main handle (A) and
,.B
the other hand on the side handle (B).
Dust
Collection
(Fig.
1)
A WARNING:
To reduce
the
risk
of injury, turn unit off and disconnect it from power source
before installing and removing accessories, before adjusting
or when making repairs. Be sure the switch is in the "OFF" position.
An accidental start-up can cause injury,
WARNING: To reduce the risk of serious personal injury, NEVER
operate this tool with perforated paper unless the dust collection
system is in place.
,_WARNING:
Empty dust collection system frequently, especially
when sanding resin-coated surfaces such as polyurethane, varnish,
shellac, etc. Dispose of coated dust particles according to the finish
manufacturer's guidelines, or place in a metal can with a tight fitting
metal lid. Remove coated dust particles from the premises daily,
The accumulation of fine sanding dust particles may self ignite and
cause fire.
Attach vacuum hose to the dust port (D).
Using
the
Sander
(Fig.
7)
To operate your sander, grasp it as shown in Figure 7. Hold the tool
firmly and turn it on. Apply the sanding disc to the workpiece and
apply slight pressure only. Be sure to check your work often. This
sander is capable of removing material rapidly, especially with coarse
paper.
To produce the best finish possible, start with coarse grit sandpaper
and change gradually to finer and finer paper. Vacuum and wipe the
surface with a tack cloth between grit steps.
When sanding painted surfaces (see Additional Safety Rules for
Paint Removal), you may find that the sandpaper clogs with paint.
A heat gun will work much better to remove paint before sanding.
Follow all the safety instructions in the heat gun instruction manual.
MAINTENANCE
A WARNING:
To reduce
the risk of injury, turn
unit off
and disconnect
it from power
source before installing and
removing
accessories,
before
adjusting
or when
making
repairs. An accidental start-up can cause injury,
Cleaning
i_ WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
_WARNING:
Never use solvents or other harsh chemicals
for
cleaning the non-metallic parts of the tool These chemicals may
weaken the plastic materials used in these parts.
Use a cloth
Hide quick links:
Advertisement
Table of Contents
