GE JSP28 Use & Care Manual page 24

OPERATING THE SELF-CLEANING OVEN
How to Set Oven for Cleaning
Quick Reminder:
1.
Press the CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
cycle, the word "OFF" will appear in the display.
Allow additional time for cooling before you try to
set the cycle.
C L E A N
1.
Follow the steps in the Before a Clean Cycle
section.
2. After closing the door, press the
CLEAN pad.
u
displayed.
Clean Time is normally 3 hours.
depending on how dirty your oven is.
C L E A R
To Stop a Clean Cycle
1. Press the CLEAIUOFF pad.
24
(continued)
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the wcid "ON" appears in
the display. When the oven heats to a high temperature,
the word "LOCK" will appear in the display. It will not
be possible to open the oven door until the temperature
drops below the lock temperature and the LOCK light
goes off.
4. When the LOCK light is off, open the door.
NOTE:
You can find out when the clean cycle will be
finished by pressing the STOP TIME button.
The word "door" will be displayed, the word
"LOCK" will flash and oven control will signal if you
set the clean cycle and forget to close the oven door.
A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
2. When the LOCK light goes off and the oven has
cooled below the locking temperature, open the door.