Wash Cycles And Options; Table Of Wash Cycles; Wash Options - Hotpoint AQUALTIS AQD970D 49 Instructions For Installation And Use Manual

Wash cycles and options

Table of wash cycles

Icon Description of the wash cycle
Cotton Coloureds (2): lightly soiled whites and delicate colours.
Synthetics Resistant
Synthetics Resistant (4)
Whites
Coloureds (3)
Darks
Wool Platinum Care: for wool, cashmere, etc.
Ultradelicates
Anti Allergy
Rinse
Spin and Pump out
Wash&Dry
Drying Cottons
Drying Wool
Drying Synthetics
Cotton Hygiene Prewash
(Add detergent to the relevant compartment).
Cotton Whites (1): heavily soiled whites and resistant colours.
The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as
water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected.
(*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the load inside it; this value will then be shown on the display.
For all Test Institutes:
1) Test wash cycle in compliance with regulation EN 50229: set wash cycle
2) Long wash cycle for cottons: set wash cycle
3) Short wash cycle for cottons: set wash cycle
4) Long wash cycle for synthetics: set wash cycle

Wash options

Super Wash
3
1
2
compartment 1. When pouring in the bleach, be careful
not to exceed the "max" level marked on the central pivot
(see figure). To bleach laundry without carrying out a full
wash cycle, pour the bleach into the extra compartment 3,
select the "Rinse" cycle and activate the "Super Wash"
option .
! It cannot be used in conjunction with
.
, , , ,
Extra rinse
By selecting this option, the efficiency of the rinse is
increased and optimal residual detergent removal is
guaranteed. It is particularly useful for skin which is
with a temperature of 60°C.
with a temperature of 40°C.
with a temperature of 40°C.
with a temperature of 40°C.
This option offers a high-
performance wash due to
the greater quantity of water
used in the initial phase
of the cycle, and due to
the increased wash cycle
duration, is particularly useful
for the removal of stubborn
stains. It can be used with or
without bleach. If you desire
bleaching, insert the extra
tray compartment (3) into
, ,
, , ,
Max.
Max. temp.
speed Drying
(°C)
(rpm)
wash
40° 1400 
60° 800 
40° 800

60° 1400 
40° 1400 
30° 800

40° 800 
30° 0

60° 1400 
- 1400

- 1400 
30° 1400 
- -

- -

- - 
90° 1400 
60°
1400 
(Max. 90°C)
sensitive to detergents. We recommend this option is used
with a full load of washing, or when a large amount of
detergent is required.
! It cannot be used in conjunction with
, , .
Easy Iron
By selecting this option, the wash and spin cycles will be
modified in order to reduce the formation of creases.
At the end of the cycle the Washer-dryer drum will
rotate slowly; the "Easy Iron" and START/PAUSE indicator
lights will flash. To end the cycle press the START/PAUSE
button or the "Easy Iron" button.
! It cannot be used in conjunction with
.
, ,
Note: If you also want to run the drying cycle, this option is
enabled only if combined with level "Iron".
Time Saver
If you select this option, the wash cycle duration will be
reduced by up to 50%, depending on the selected cycle,
,
thereby guaranteeing simultaneous water and energy
saving. Use this cycle for lightly soiled garments.
! It cannot be used in conjunction with
,
, , , ,
Detergent and additives
Max.
load
Pre- Fabric
Wash Bleach
(kg)
softener
-
  
-   
-
  
- -
 
-   
- -
 
- -
  2,5
- -
 
-  - 
- -
 
- - - -
-  - 
- - - -
- - - - 2,5
- - - -
  - 
-   
, ,
,
, ,
,
,
.
EN
Cycle
duration
9
5
5
6
6
6
1
6
9
9
1
7
5
9
9
,
, ,
, ,
,
, ,
7 7