Printed Wiring Board; Printed Wiring Boards And Schematic Diagrams - Sony SLV-EX5 Service Manual

QQ
3 7 63 1515 0

PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For printed wiring board:
X : indicates a lead wire mounted on the component
•
side.
x : indicates a lead wire mounted on the printed side.
•
• a : Through hole.
b : Pattern from the side which enables seeing.
•
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
(Side B)
Parts face side:
(Side A)
TE
L 13942296513
www
.
http://www.xiaoyu163.com
Parts on the pattern face side seen from
the pattern face are indicated.
Parts on the parts face side seen from
the parts face are indicated.
x ao
y
i
http://www.xiaoyu163.com
SECTION 4
8
For schematic Diagram:
• Caution when replacing chip parts.
New parts must be attached after removal of chip.
Be careful not to heat the minus side of tantalum capacitor,
because it is damaged by the heat.
• All resistors are in ohms,
less otherwise specified.
kΩ : 1000Ω, MΩ : 1000kΩ.
• All capacitors are in µF unless otherwise noted. pF : µµF
50V or less are not indicated except for electrolytics and
tantalums.
• All variable and adjustable resistors have characteristic curve
B, unless otherwise noted.
2 : nonflammable resistor.
•
5 : fusible resistor.
•
• C : panel designation.
• f : internal component.
C : adjustment for repair.
•
U
• : B+ Line.
V
• : B– Line.
• Circled numbers refer to waveforms.
• Voltages are dc between measurement point.
• Readings are taken with a color-bar signal input.
• Readings are taken with a digital multimeter (DC 10MΩ).
• Voltage variations may be noted due to normal production
tolerances.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
When indicating parts by reference
number, please include the board
name.
Q Q
3 6 7 1 3
u163
.
4-1
SLV-EX5/EX8S/EX9S
2 9 9 4 2 8
1
/ W (Chip resistors :
4
1 5 0 5 8 2 9 9 4
m
co
9 9
1
/ W) un-
10
2 8 9 9