Black & Decker KA300 Instruction Manual page 5

Using an extension cable
Always use an approved extension cable suitable for
the power input of this tool (see technical data). Before
use, inspect the extension cable for signs of damage,
wear and ageing. Replace the extension cable if
damaged or defective. When using a cable reel, always
unwind the cable completely. Use of an extension cable
not suitable for the power input of the tool or which is
damaged or defective may result in a risk of fire and
electric shock.
Features
1. On/off switch
2. Dust extraction outlet
3. Paper clamp lever
4. Sanding base
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting sanding sheets (fig. A)
Warning! Never use the tool without a sanding sheet or
accessory in place.
Fitting regular sanding sheets (fig. A)
Warning! Make sure that the tool is switched off and
unplugged.
Soften the sanding sheet by rubbing its non-abrasive
side over the edge of a worktop.
Press the paper clamp levers (3) upwards to release
them from the retaining grooves and open the paper
clamps (3) by pressing them down.
Place the sheet onto the sanding base (4).
Insert the edge of the sanding sheet into the front paper
clamp (3) as shown.
Press the front paper clamp lever (3) downwards and
locate it in the retaining groove.
While keeping a slight tension on the sheet, insert the
rear edge of the sheet into the rear paper clamp (3).
Press the rear paper clamp lever (3) downwards and
locate it in the retaining groove.
Connecting a vacuum cleaner (fig. C)
Insert the adaptor (5) into the dust extraction outlet (2).
Connect the hose (6) of the vacuum cleaner to the
adaptor (5).
Use
Warning! Let the tool work at its own pace. Do not overload.
Switching on and off (fig. B)
To switch the tool on, press the part of the on/off switch
(1) marked 'I'.
To switch the tool off, press the part of the on/off switch
(1) marked '0'.
Hints for optimum use
Do not place your hands over the ventilation slots.
Always hold the tool with both hands (fig. D).
Do not exert too much pressure on the tool.
Regularly check the condition of the sanding sheet.
Replace when necessary.
Always sand with the grain of the wood (fig. D).
When sanding new layers of paint before applying
another layer, use extra fine grit.
On very uneven surfaces, or when removing layers of
paint, start with a coarse grit. On other surfaces, start
with a medium grit. In both cases, gradually change to a
fine grit for a smooth finish.
Consult your retailer for more information on available
accessories.
Maintenance
Your Black & Decker tool has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Before performing any maintenance, switch off and
unplug the tool.
Regularly clean the ventilation slots in your tool using a
soft dry brush or dry cloth.
Regularly clean the motor housing using a clean damp
cloth. Do not use any abrasive or solvent-based
cleaner.
Protecting the environment
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again. Re-
use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have
reached the end of their working life. To take advantage of
ENGLISH
5