Denon AVR-1705 Operating Instructions Manual page 15

10
Press the (down) button to switch the DIGITAL input (COAX) setting.
Setting the Digital In assignment
Input the type of components connected to the digital input terminals.
1
Use the (left) and
the COAXIAL input (COAXIAL) terminal.
16 COAX CD
• Select "OFF" if nothing is connected.
Press the ENTER or
setting.
2
Use the (left) and
the OPTICAL input 1 (OPTICAL 1) terminal.
17 OPT1 DVD
• Select "OFF" if nothing is connected.
Press the ENTER or
setting.
3
Use the (left) and
the OPTICAL input 2 (OPTICAL 2) terminal.
18 OPT2 TV
• Select "OFF" if nothing is connected.
Press the ENTER or
NOTE:
• TUNER, V. AUX cannot be selected.
(right) buttons to assign the input function connected to
(Initial)
CD AUX DVD TV VCR CDR
(left) button (right) button
(down) button to switch the optical input 1 (OPT1)
(right) buttons to assign the input function connected to
(Initial)
CD AUX DVD TV VCR CDR
(left) button (right) button
(down) button to switch the optical input 2 (OPT2)
(right) buttons to assign the input function connected to
(Initial)
CD AUX DVD TV VCR CDR
(left) button (right) button
(down) button to switch the Auto Surround Mode setting.
Setting the Auto Surround Mode
For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory.
At next time it the same signal inputs, the memorized surround mode is automatically selected and the signal
is played.
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL
q
Analog and PCM 2-channel signals
w
2-channel signals of Dolby Digital, DTS or other multichannel format
e
Multichannel signals of Dolby Digital, DTS or other multichannel format
1
Use the
OFF
Press the ENTER or
Setting the Ext. In SW Level
Set the method of playback of the analog input signal connected to the Ext. In terminal.
1
Use the
OFF
Level playback.
Press the ENTER or
the beginning.
After setting up the system
OFF
1
Press the SYSTEM SETUP button to finish system set up.
This completes the system setup operations. Once the system is set up, there is no need to make the
settings again unless other components or speakers are connected to or the speaker layout is changed.
Default Auto Surround Mode
STEREO
Dolby PL
Dolby or DTS Surround
(left) and (right) buttons to select the Auto Surround mode.
(Initial)
ON OFF
19 AUTOSURR. ON
(left) button (right) button
(down) button to switch the Ext. In SW Level setting.
(left) and (right) buttons to select the Ext. In Subwoofer channel
+00 +05
20 EXT.IN SW +15
(left) button (right) button
(down) button if you want to start the settings over from
ENGLISH
II
x Cinema
(Initial)
+10 +15
15