Zanussi ZWD 12270 W User Manual page 18

Operating sequence
To interrupt a programme which is running,
depress the Start/Pause button: the
corresponding green pilot light starts to flash.
To restart the programme from the point at
which it was interrupted, press the Start/Pause
button again.
IMPORTANT!
If an incorrect option is selected, the red pilot
light of the Start/ Pause button flashes for 3
times and the message Err is displayed for
about 2 seconds.
9. Select the Drying Time
1.00
By depressing this button you can select a
timed programme for cotton or synthetics. The
relevant light illuminates.
For Cottons and Synthetics you can select a
drying time from 10 minutes to 130 minutes
). Every time you press the button the
2.10
(
time increases by 5 mins.
Note!
The programme time will automatically increase
by up to 2 minutes. this is quite normal.
10. Programme progress display
When selecting the programmes, depending on
the programme selected, the «Wash» or the
«Dry» pilot light illuminates and stays on while
the machine is working.
18
Drying Time
Wash
Dry
End
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washer-dryer by pressing the Start/Pause
button.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to Off and then to the new
programme position. The washing water in the
tub will not emptied out. Start the new
programme by depressing the Start/Pause
button again.
Interrupting a programme
Depress the Start/Pause button to interrupt a
programme which is running, the
corresponding light starts to flash. Depress the
button again to restart the programme.
Cancelling a programme
Turn the selector dial to «Off» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
Start/Pause button. After few minutes, the door
can be opened.
If the door remains locked, this means that the
machine is already heating, that the water level
is above the bottom edge of the door or that
the drum is turning.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off». After few
When the programme
has finished, the «End»
pilot light illuminates
and the «Wash» or
«Dry» light go off.