Table of Contents
Advertisement
LabVIEW Real-Time with the Vision Development
Module: Setting up the Development Computer
Installing LabVIEW Real-Time, Vision Development Module,
and NI-IMAQ for IEEE 1394 Cameras
Note
You must install LabVIEW, LabVIEW Real-Time, and the Vision Development
Module software before installing the NI-IMAQ for IEEE 1394 Cameras driver software.
© National Instruments Corporation
This section describes the sequence for installing the application and driver
software on the development computer, obtaining an IP address, installing
software on the NI 1450, and configuring the NI 1450 to acquire an image
using LabVIEW Real-Time.
This section applies only to LabVIEW Real-Time users. If you are using the
Vision Builder AI software, refer to the
Development Computer
The following items are necessary for setting up the development
computer.
❑
LabVIEW and LabVIEW Real-Time software
❑
Vision Development Module software
❑
NI-IMAQ for IEEE 1394 Cameras driver software
Complete the following steps to install LabVIEW, LabVIEW Real-Time,
the Vision Development Module, and the NI-IMAQ for IEEE 1394
Cameras software onto the development computer.
1.
Insert the LabVIEW CD into the CD-ROM drive.
2.
When the installation splash screen appears, click Install LabVIEW
and follow the setup instructions.
3.
Insert the LabVIEW Real-Time CD into the CD-ROM drive.
4.
When the installation splash screen appears, click Install LabVIEW
Real-Time and follow the setup instructions.
5.
Insert the Vision Development Module CD into the CD-ROM drive.
6.
When the splash screen appears, click Install Vision 7.0 Development
Module and follow the setup instructions.
Vision Builder AI: Setting up the
section.
2-15
NI 1450 Series Compact Vision System User Manual
Chapter 2
Setup and Configuration
Advertisement
Table of Contents
