Mitsubishi H2i-R2-1 Manual page 258

8. OPTIONAL PARTS
8-2. Twinning Kit
Twinning kit is needed to combine the refrigerant flows of the PURY-HP-TKMU/YKMU units for the combined
PURY-HP-TSKMU/YSKMU systems.
CMY-R100CBK2
Low-pressure pipe twinning kit
1"
1-3/32"
5-1/4"
High-pressure twinning pipe
7/8"
3-5/32"
<Deformed pipe(Accessory)>
3/4"
(Outside diameter)
Note 1. Reference the attitude angle of the branch pipe below the fig.
The angle of the branch pipe for hign pressure is within
2. Use the attached pipe to braze the port-opening of the distributer.
3. Pipe diameter is indicated by inside diameter.
4. Only use the Twinning pipe by Mitsubishi (optional parts) .
H2i-R2-258
PURY-HP-T(S)KMU,-Y(S)KMU (September 2014)
1"
(Outside diameter)
4-5/32"
17-1/32"
<Low-pressure pipe twinning kit(Accessory)>
1"
1"
3-5/32"
<Pipe for routing through the bottom
(Accessory)>
3/4"
3/4"
1"
(Outside diameter)
3/4" 8-7/16"
5/8"
2-15/32"
(3Pcs.)
Distributer
15
<Elbow pipe(Accessory)>
1-5/32"
1-5/32"
1-31/32"
1-5/32"
(Outside diameter)
7/8"
7/8"
7/8"
1-7/16"
(Outside diameter)
21/32"
<Deformed pipe(Accessory)>
7/8"
(Outside diameter)
2-15/32"
<Pipe for routing through the front
(Accessory)>
1"
3/4"
4-17/32" 7-17/32"
against the horizontal plane.
3/4"
Ref: CMY_R100VBK_EXD_EUDB_SI
© 2014 Mitsubishi Electric US, Inc.