To Charge In Car - Stanley Simple Start P2G7S Quick Start Manual

HOW TO CHARGE THE UNIT IN YOUR CAR
1. Connect the DC charging cable to the Unit's dual Pin
Connector and plug it into the vehicle's accessory outlet.
2. Press the Main Power button to turn the unit ON.*
3. Depending on vehicle voltage the unit may start to flash
blue indicating it is recharging.
4. The LED Indicator ring will flash blue when charging and
light solid blue when fully charged
If the LED indicator flashes red, yellow or
green, then press the USB/Light button
for 5 seconds and release to force the
unit into charging mode.
*Note: Some vehicles may require you to turn the ignition key to the ACC (accessory) position to activate the
DC accessory outlet.
Charging
Fully Charged