Axis P3364-VE Installation Manual page 21

AXIS P33-VE Network Cameras Installation Guide
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the factory default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power (see
3. Keep the Control button pressed for about 15 seconds until the Status indicator displays amber.
4. Release the Control button. The process is complete after about 1 minute (when the Status
indicator turns green). The network camera has been reset to the factory default settings. The
default IP address is 192.168.0.90
5. Re-assign the IP address.
6. Refocus the camera.
It is also possible to reset parameters to factory default via the web interface. Go to Setup > System
Options > Maintenance.
Accessing the camera from the Internet
Once installed, your AXIS P3363-VE/P3364-VE is accessible on your local network (LAN). To access
the camera from the Internet, network routers must be configured to allow incoming traffic, which
is usually done on a specific port
• HTTP port (default port 80) for viewing and configuration
• RTSP port (default port 554) for viewing H.264 video streams
Please refer to the documentation for your router for further instructions. For more information on
this and other topics, visit the Axis Support Web at www.axis.com/techsup
Further information
The user manual is available from the Axis Web site at www.axis.com. To learn more about Axis'
products and technologies, visit www.axis.com/academy, the global learning center for network
video.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your Axis product.
To see the currently installed firmware version, see Setup > About in your web interface.
"Hardware overview"
on page 6).
Page 21