Sanyo MPX-CD92P Instruction Manual page 2

PRECAUTION
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR OTHER MOISTURE.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
If the power supply cord (AC power cord) of this
appliance is damaged, it must be replaced. Return to a
SANYO Authorised Service Centre for replacement of
the cord.
Location
For safe operation and satisfactory performance of your
multiplexer, keep the following in mind when selecting a place
for its installation:
• Shield it from direct sunlight and keep it away from sources of
intense heat.
• Avoid dusty or humid places.
• Avoid places with insufficient ventilation for proper heat
dissipation. Do not block the ventilation holes at the top and
bottom of the multiplexer. Do not place the unit on a carpet
because this will block the ventilation holes.
•
Install the multiplexer in a horizontal position only.
• Avoid locations subject to strong vibrations.
• Avoid moving the multiplexer between cold and hot locations.
•
Do not place the multiplexer directly on top of a monitor TV,
as this may cause playback or recording problems.
Avoiding Electrical Shock and Fire
• Do not handle the power cord with wet hands.
• Do not pull on the power cord when disconnecting it from an
AC wall outlet. Grasp it by the plug.
• If any liquid is spilled on the multiplexer, unplug the power
cord immediately and have the unit inspected at a
factory-authorised service centre.
• Do not place anything directly on top of this multiplexer.
SERVICE
This unit is a precision instruments and if treated with care, will
provide years of satisfactory performance. However, in the event
of a problem, the owner is advised not to attempt to make
repairs or open the cabinet. Servicing should always be referred
to your dealer or Sanyo Authorized Service Centre.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer.
Discard used batteries according to the manufacture's
instructions.
English
1