Page 6
Disassembly guide • 2. Battery caver disassembly • open the battery cover,as the Fig. 1 Battery cover Fig. 1...
Page 7
Disassembly guide • 3. Back caver disassembly • 1) Unscrew 11 screws in back cover ,as the Fig.2; Fig. 2...
Page 8
Disassembly guide • 2) Disassemble back cover with Tommy bar ,as the Fig.3; Back cover Fig.3...
Page 9
Disassembly guide • 4.Main board and front cover disassembly • 1)The main components of distribution,as the Fig.4; Earphone con RF cable T card con SIM1 card con ANT clip TP con Main PCB 8M camera USB con BAT con 5M camera LCD con vibrator SIM2 card con...
Page 10
Disassembly guide • 2)remove 1 screws and open the LCD con.& TP con. ,and remove the volume key FPC & power key FPC as the Fig.5; TP con LCD con Fig.5...
Page 11
Disassembly guide • 3)open the main board and remove the RF cable con. And main FPC con..as the Fig.6 accelerator sensor RF part AP part Main FPC con Fig.6...
Page 12
Disassembly guide • 5. 5M front and 5M rear camera & light sensor disassembly remove the light sensor and 5M front camera,as the Fig.7; 5M front camera 5M rear camera light & distance sensor Fig.7...
Page 13
Disassembly guide • 6.Power key FPC & volume key FPC disassembly remove the power key FPC and volume key FPC with the iron,as the Fig.8; Volume key FPC Power key FPC Fig.8...
Page 14
Disassembly guide • 7. Speaker & receiver disassembly remove the Speaker camera and receiver,as the Fig.9; Receiver Speaker Fig.9...
Page 15
Disassembly guide • 8. RF cable and Main FPC disassembly Remove the RF cable and Main FPC ,as the Fig.10 Fig.10...
Page 16
Disassembly guide • 9. Sub PCBA disassembly remove the sub PCBA from the ,as the Fig.11; Fig.11...
Page 17
Disassembly guide • 10.MIC disassembly Remove the MIC,as the Fig.12; Fig.12...
Repairing guide 1. LCD a. Check if the SW is correct, otherwise to upgrade the SW; b. Check the LCD if is ok, otherwise change a new LCD; c. If that the LCD loose, re-assemble the LCD and test; d. Checking the LCD connector if is ok, otherwise re-solder it or change a new one;...
Page 20
Repairing guide 2. Camera a. Checking the camera is assemble ok, re-assemble the camera and test; b. Using the good camera to do cross test, it can check if the camera is c. Checking the camera connector if is ok as below picture, otherwise to re-solder or change a new one;...
Page 21
Repairing guide 3. TP a. Checking the SW and upgrade the SW; b. Checking the FPC of TP and re-assemble it; c. Using the good TP to do cross test; d. Checking the TP connector, otherwise re-solder or change a new one;...
Page 22
Repairing guide 4.Ring a. Checking the shrapnel of speaker if is ok; b. Checking the resistance of speaker if is ok, otherwise to change a new one; c. Checking the FPC if is ok; d. Checking SPK-FPC if connector with sub-board is ok.
Page 23
Repairing guide 5.receiver a. Checking the shrapnel of receiver if is ok; b. Checking the resistance of receiver if is ok, otherwise to change a new one; c. Checking the connector point on the main board if is ok, as below picture;...
Page 24
Repairing guide 6.MIC and Vibrator a. Checking the MIC and Vibrator is cold soldering, re-solder it; b. Change the MIC and Vibrator; c. Checking the circuit of MIC and Vibrator; d. Checking the FPC if connect ok. vibrator...
Page 25
Repairing guide 7. Earphone a. Checking the shrapnel of earphone if is ok; b. Checking the connector point on the main board if is ok, as below picture; c. Change earphone connector; c. Checking the circuit of earphone.
Page 26
Repairing guide 8.No Power On a. Checking the voltage of battery if is 3.8-4.2V and connect ok; b. Upgrade the SW; b. Checking the power on key and circuit around it.;...
Page 27
Repairing guide 9.No charging a. Checking the voltage of battery if is over 3.4V; b. Checking the charger and USB cable if is ok; c. Checking the USB connector and circuit if is ok.
Page 28
Repairing guide 10.No SIM card and No memory card a. Checking the connector of T –card and SIM card; b. Change the connector of T –card and SIM card; T card con SIM1 card con SIM2 card con...
Page 29
Repairing guide 11.Signal a. Checking RF line if that is broken; b. Checking RF line assemble if is ok; RF con RF con...
Need help?
Do you have a question about the A94 and is the answer not in the manual?
Questions and answers