4: Adding The Device - FIBARO SWIPE FGGC-001 Operating Manual

8
i
NOTE
Adding in security
mode must be per-
formed up to 2 meters
from the controller.
i
NOTE
In case the device is
not added, please re-
set the device and re-
peat the adding pro-
cedure.
ADDInG ThE DEVICE

#4: Adding the device

Adding (Inclusion) - Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
To add the device to the Z-Wave network:
1. Place the Swipe within the direct range of your Z-Wave controller.
2. Set the main controller in (security/non-security) add mode (see
the controller's manual).
3. Move and hold your hand close to the center of the pad.
4. If the device is battery powered, high pitched beep will signal
exiting the Standby Mode.
5. Loud sound sequence will confirm entering the menu, keep
holding your hand.
6. After hearing two short beeps (green indicator colour), withdraw
the hand and perform swiping up gesture to confirm selection
(two beeps will confirm validity).
7. Wait for the adding process to end.
8. Successful adding will be confirmed by the Z-Wave controller's
message and 3 short beeps (green visual indicator colour).