SlipStream 30cc RV8 Assembly Manual page 6

pre-aligned for your convenience.
ENGINE EXHAUST & FUEL SYSTEM INSTALLATION:
1. Use the provided template that comes with your engine (if provided) to align the
engine. The center line for the mounting of the engine is marked on the firewall.
2. Use the guide to align the engine and drill the mounting holes. You may have to
cut the firewall as necessary if using a rear-carburetor engine. Notice that the
engine center line is offset to the 1eft to compensate for the right thrust built into
the engine box.
.
3. Place the cowling in place on the fuselage and measure the distance from the
firewall to about 0.5 inch in front of the cowling. This figure represents the back of
the spinner and will help you determine if you need to space your engine out from
the firewall using washers or additional wood. Mount your engine securely using
bolts, washers. and locknuts and according to the manufacturer's instructions. The
use of thread-lock is also highly recommended for the engine bolts. The pictures
below show the different type of engines that can be mounted (side of rear-
carburetor).