Page 1
LBI-38952A Mobile Communications MDR™ GE-MARC MOBILE RADIO TABLE OF CONTENTS DUPLEXER INTERFACE BOARD ....LBI-38700 RF BOARD ....... LBI-38841 SYSTEM BOARD .
GENERAL DESCRIPTION receiver squelch. 3.5 inch and 5.25 inch diskettes. The RF board includes the programmable frequency synthe- The Ericsson GE-MARC V•E MDR Mobile Radio is a LOGIC BOARD PC PROGRAMMED OPTIONS sizer, transmitter exciter, receiver front end and IF circuitry.
LBI-38952 LBI-38952 standard 3’ handset cable, Option PMCD1M (19B802397P1). Hook Switch Programming Option OPERATIONAL MODES SYSTEM DESCRIPTION In-line connector, Option PMCN1A (19A705839P1), must be used to mate the cables. It is recommended that Handset "Off Hook Call" originate and "On Hook Call" termi- The radio will always be in one of three operational modes: Extension Cable Kit, Option PMZM5V, be used in remote The GE-MARC V•E trunked mobile radio system permits...
LBI-38952 LBI-38952 IDLE MODE WAIT MODE When the radio is in the Idle Mode, the audio is muted and When the user enters the Wait Mode, the display group is all channels programmed for call decode are sequentially checked to make sure it is a valid call-originate group. If it is not scanned for an incoming call.
LBI-38952 LBI-38952 Group/Individual Tones STATUS INDICATORS GLOSSARY OF SYSTEM TERMS AUDIBLE INDICATORS Group/Individual tones chosen from the 34 standard fre- quencies, follow the collect tone. In a two-tone call, the second Idle Mode No Service SELF CHECK TEST ALERT tone is sent for 450 milliseconds. In a four-tone call, the second, third, and fourth tones are sent for 90 milliseconds from the In the "standby"...
LBI-38952 LBI-38952 5 (JKL) SIMPLEX Disables duplex, allows simplex I NVALID CAL L ORIG INATE ALERT Volume Up (VOLUP) Alphabet Keys ( A, B, C) operation. (Trunked mode only) The VOLUP key is located on the left side of the handset. The A, B, C keys are "Hotkeys"...
LBI-38952 LBI-38952 be entered directly by entering the desired group number and If the call retry option was enabled during PC program- and the AREA and INDIVIDUAL decode when an INDIVID- BASIC OPERATION then pressing the (#) key. ming, [RETRYING] will appear in the display instead UAL call is received.
LBI-38952 LBI-38952 Call Timer Recalling Numbers Locking The MDR Mobile Radio DTMF Digit Length The user can recall numbers previously stored by follow- The call timer displays the length of the time the conver- The user may choose to lock the radio by pressing the FCN The user can change the duration of the DTMF tones by ing these steps: sation in progress, or most recent call, has taken.
Need help?
Do you have a question about the MDR GE-MARC and is the answer not in the manual?
Questions and answers