Hard Disk Installation And Connnection To Dvr; Installing The Hard Disk - Sanyo VA-EXH Instruction Manual

e00_l8hcb_us_7.book Page 5 Monday, March 7, 2005 3:54 PM
1

HARD DISK INSTALLATION AND CONNNECTION TO DVR

Installing the hard disk

Use the following procedures to install the hard disk in the
external storage unit.
The external storage unit must be off before commencing
the following procedures.
Use only S-ATA hard disks from Sanyo. Operation by other
hard disks is not guaranteed. Contact the dealer for details.
1
Remove the four screws (two on each
side) securing the cover, and remove
the cover.
2
Remove the hard disk bay.
Remove the four screws (two on each side), and remove the
hard disk bay on top of the installation block.
Front panel side
Screws
The position of the hard disk differs according to the
number of units being installed. Numbers are marked near
the hard disk bay. Follow the chart below.
No. of units Position
1
1
1 2
2 ,
The positions are shown below.
1
3
English
Hard disk bay
Screws
No. of units Position
1 2 3
3 , ,
1 2 3 4
4 , , ,
2
4
5
To install the hard disk in positions
installation block, and then the hard disk bay.
[Removing the installation block]
(1) Remove the nine screws.
(2) Slide the center of the front part toward the back panel
and remove the hard disk installation block.
Position
markings
( -
1 4
Screws
Screws
For instructions on how to attach the installation block, see
[Attaching the installation block]. ( P.8)
3
Attach the hard disk bay removed in
step 2 to the hard disk.
Secure the screws in the order (1-4) marked on the hard disk
bay.
Ensure the fittings exceed 10 mm in height.
If not, repair them.
Fitting
"2"
"3"
"4"
"1"
* Tightening torque: 0.5 N•m - 0.6 N•m (5 - 6 kgf•cm)
Do not use a torque screwdriver.
3 and 4 , remove the
)
Screws
Bring the hard disk
connector to the side
with "CN."