Electrical Safety; Package Contents - DeWalt DC927 Instruction Manual

EN GLI SH
Battery charged
Battery defective
Hot\cold pack delay
Do not probe with conductive objects.
Do not charge damaged battery packs
Use only with D WALT battery packs,
E
others may burst, causing personal injury
and damage.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 °C and 40 °C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack
NiMH, NiCd+ and Li-Ion.
Charges NiMH and NiCd
battery packs.
Charges Li-Ion battery packs.
See technical data for charging time.

Package Contents

The package contains:
1 Cordless hammerdrill
1 Side handle
2 Battery packs
1 Charger
1 Instruction manual
1 Exploded drawing
NOTE: Battery packs and chargers are not included
with N-models.
34
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1–5)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger switch
b. Forward/reverse control button
c. Mode control collar
d. Torque adjustment collar
e. Gear shifter
f. Chuck sleeve
g. battery release buttons
INTENDED USE
Your DC927 hammerdrill has been designed for
professional drilling, hammer drilling and screwdriving
applications
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These hammerdrills are professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains Plug Replacement
(U.K. & Ireland Only)
DANGER:
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E