Disassembly & Reassembly - Samsung SyncMaster 510MP Service Manual

3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
MH15AS/MH17AS monitor.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
3-1 Disassembly
Cautions : 1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3. R/Cover opening jig : BH81-00001A
MH15AS/MH17AS
1. Place monitor face down on cushioned table.
Remove 4 screws from grip on the stand and
insert the opening jig into the grooves at each
side and press until it clicks.
2. Remove rear cover from the monitor and
remove 2 screws from the main shield.
3. Remove 2 screws from the shield and
disconnect scart cable. Lift up the start cable
from the shield.
4. Disconnect speaker cable and function cable
from the shield PCB and remove shield PCB.
Disconnect inverter cables, LVDS cable from
the MAIN board.
3-1