Advertisement
COOKTOP OPERATION
Cooktop Operation
DUAL-ZONE OR OVAL ELEMENT (ELECTRIC)
Setting controls:
To activate dual-zone or oval element, touch
1
control panel. Power level indicator will flash and all
indicators for that zone will flash.
Set desired heat level for inner zone as described
2
on page 7. Outer zones cannot be turned on indepen-
dently of inner zone.
Touch
or
. Outer zone will be set to the same
3
heat setting as inner zone.
or
will illuminate to
indicate outer zone is on.
Change heat setting for entire dual-zone or oval element
4
the same as for a single element. Both zones maintain
the same heat setting.
To turn outer zone off, touch
or
. To turn entire
5
element off, touch
.
|
8
English
TRIPLE-ZONE ELEMENT (ELECTRIC)
Setting controls:
on the
To activate triple-zone element, touch
1
panel. Power level indicator will flash and all indicators
for that zone will flash.
Set desired heat level for inner zone as described
2
on page 7. Outer zones cannot be turned on indepen-
dently of inner zone.
Touch
. Middle zone will be set to the same heat set-
3
ting as inner zone.
will illuminate to indicate middle
zone is on.
Touch
. Outer zone will be set to the same heat set-
4
ting as inner and middle zones.
indicate outer zone is on.
Change heat setting for entire triple-zone element the
5
same as for a single element. All three zones maintain
the same heat setting.
To turn outer zone off, touch
. To turn middle zone off,
6
touch
. To turn entire element off, touch
BRIDGE ELEMENT (INDUCTION)
Setting controls:
on the control
To activate bridge, select desired power level on one of
1
the single elements.
Touch
between corresponding element controls to
2
bridge elements front to back,
side to side, or
to bridge all elements.
will illuminate respectively.
To change power level, adjust the power level on any
3
active bridged element.
To turn off, touch
4
element.
will illuminate to
For 914 mm induction cooktops,
cookware larger than 305 mm in diameter. For smaller cook-
ware, use the right rear element.
.
BRIDGE ELEMENT (ELECTRIC)
Setting controls:
To activate bridge element, select desired power level on
1
one of the single elements.
Touch
2
to bridge elements
To change power level, adjust the power level on either
3
,
or
active bridged element.
To turn off, touch
4
on any active bridged
should be used for
.
will illuminate.
on either active bridged element.
Advertisement
