Assembly; Drive Shaft/Handle Assembly; Drive Shaft/Power Head; Throttle Linkage And Ignition Leads - Echo PowerPruner PPT-266/H Operator's Manual

ASSEMBLY

ASSEMBLY

Drive Shaft/Handle Assembly

1. Remove protective caps from handle assembly.
2. Loosen clamping bolts (A) on drive shaft.
3. Pull flexible drive shaft coupler (B) 2-3 inches out of handle
assembly.
4. Align flexible drive shaft coupler with drive shaft socket and
slide together until handle assembly is fully seated into drive
shaft.
5. Tighten clamping bolts (A).

Drive Shaft/Power Head

1. Stand power head upright on a level surface.
2. Loosen the drive shaft clamp bolt (A) at engine drive shaft
clamp.
3. Remove dust cap if necessary, and carefully fit drive shaft
assembly to engine making sure that inner drive shaft
engages into clutch mount.
Note: Gear Housing must be aligned properly with engine.
4. Tighten drive shaft clamp bolt (A) securely.
5. Route throttle linkage and ignition lead assembly through
clip below fan housing.
16
PPT-266/H
A
B
I
A
I
© 10/2014 ECHO Inc.
X7712091200