Advertisement
USING 120V POWER OUTLETS
Warning! Disconnect any power tool or accessory
from power source before making any adjustments.
Risk of accidental starting which can lead to serious
injuries. Do not expose to rain or use in damp
locations.
1) Once all assembly and adjustment steps have
been followed, plug the power outlet power cord
into a suitable grounded 120V receptacle.
2) Now the work light and/or power tools can be
connected to the power outlet (A) Fig.7.
Warning: Power outlet is rated max. 15 amps/
125 VAC. If this capacity is exceeded, the reset (B)
Fig.7 will trip and cut power to the outlets. It will be
necessary to reduce the load to prevent the reset
from tripping. Unplug power cords from power
outlet(s) and wait a few minutes, reset the power
outlets by pressing the reset switch (B).
USING WORK LIGHT
1) To use work light, install work light quick mount
support onto bed. Plug work light power cord into
power outlet. Turn the work light On using the work
light switch (A) Fig.8 found at the rear of the quick
mount support.
Replacement bulb: Max. 15 Watt, Type T-6.
USING QUICK MOUNT VISE
1) To use vise (A) Fig.9, install quick mount vise
assembly onto bed.
2) This vise comes with an adjustable jaw (B) which
can be quickly removed and repositioned in the jaw
mounting holes (C).
3) Once the jaw is placed in the desired position,
place your workpiece in between the vise jaws and
turn vise locking handle (A) Fig.10 clockwise to
tighten workpiece securely. Turn handle counter-
clockwise to loosen.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web
site for the most updated parts diagram and parts list.
OPERATION
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
Advertisement
