Electrolux ICON series Use & Care Manual page 11

Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides
(two screws on each side).
Remove hex
head drawer
screw
Do Not Remove
Other Screws
Remove
Hex
Head Drawer
Screw
CAUTION
Drawer is heavy. Use caution when lifting.
3 Lift drawer up and out to remove.
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are
fully inserted into slots on each side.
Assembly
Fully Extend
Drawer Slides
Pin
Slot
Remove hex
head drawer
screw
Remove
Hex
Head Drawer
Screw
Cabinet
Removing the Doors
2 Reinstall four drawer screws (two per side),
tighten down, and close drawer (C).
Install
Screws
(2) Each
Side
3 Check gasket seal around top, bottom, and
sides of freezer drawer.
4 If gasket is not sealed, open drawer and
slightly loosen four drawer screws (two on
each side) to allow drawer to rotate.
5 Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
Push
Against
Freezer
Drawer
A
B
6 Tighten four drawer screws.
7 Recheck gasket seal.
8 Install the toe grille by fitting into place.
11
Grab
Drawer
at Center
from Both
Sides
Then
Pull
Drawer
Out