Playing From A Usb Equipment Or Dvd/Cd Medium - I-O DATA AVeL Link AVLP2/DVDLA User Manual

Playing from a USB Equipment or DVD/CD Medium

The following describes how to play a file stored in the USB equipment or DVD/CD medium connected to the
AVeL Link Player.
Set the USB equipment or DVD/CD medium you want to play from.
１
● Setting a USB Equipment
[1] Turn on the power to the AVeL Link Player.
[2] Turn on the power to the USB equipment.
[3] Connect the USB equipment to the USB port located on the front of the AVeL Link Player.
⇒ The AVeL Link Player will recognize the USB equipment.
● The AVeL Link Player only supports USB mass storage devices formatted with FAT16 or FAT32.
To find out if your USB equipment is a USB mass storage device, check with the manufacturer of
the equipment.
● Always turn on the power to the AVeL Link Player first, before connecting the USB equipment.
(If the USB equipment is connected first, the AVeL Link Player may not recognize the equipment
correctly.)
● Some external USB hard disk drive consumes over 500mA. To connect AC adapter is required.
● Setting a DVD/CD Medium
[1] Open the tray and set the DVD/CD medium.
To open the tray, press the EJECT button on the remote controller or EJECT TRAY button on
the AVeL Link Player.
[2] Close the tray.
Press the EJECT button on the remote controller or EJECT TRAY button on the AVeL Link Player.
● It will take a few moments for the tray to open after the EJECT TRAY button on the AVeL Link
Player is pressed. Wait for a while after pressing the button.
Also note that pressing the button for a prolonged duration may cause the tray to open/close
repeatedly. Exercise caution not to press the button too long, because repeated opening/closing of
the tray may result in a pinched finger or damaged medium.
Select the source you want to play from, and then press the ENTER button on the
２
remote controller.
４４
Point!
Point!
Select.
[2] Press.
[1] Select.
[1] Select.