Get Started; Install Filters - Philips AC4012 User Manual

3 Get started

Install filters

The air purifier comes with all filters
fitted inside, but you have to remove the
packaging of the filters before you can
use it. Remove all filters, unpack them,
and place them back into the air purifier
as described below.
Note
• Insert the filters in the correct position.
• Make sure you place the filters in the
order of NanoProtect filter, NanoProtect
Activated Carbon filter, and finally the
pre-filter.
• Make sure that the side with the tag is
pointing towards you.
1
Place your fingers in the recesses of
the side panels and gently pull the
top part of the front panel towards
you.
2
Gently pull the bottom of the panel
out (1), then lift the top part of the
front panel towards you (2) (fig b).
3
Remove all the filters from the
purifier (fig c).
4
Remove all packaging material
from the filters (fig d).
5
Put the filters back into the purifier
(fig e).
6
Place the pre-filer in the purifier
(fig f).
Note
• Make sure that the side with the two
projections is pointing towards you,
and that all hooks of the pre-filter are
properly attached to the purifier.
7
To reattach the front panel, insert
the top hooks into the top of the
purifier first (1). Then, push the
panel against the body of the
purifier (2) (fig g).
EN
5