Installing Stands; Mounting Rear Satellites On Walls - Cambridge SoundWorks DTT2200 Installation And Operating Instructions Manual

5 Apply Identification Label
to back of Satellite.
1
Thread Speaker Cable
through hole in Stand.
4 Apply Identification
label to Speaker
Cable.
3
Push back red tab on Satellite.
2
Insert bare end of red-banded
cable into hole and release tab to
lock. Repeat for unmarked cable;
insert into black tab.
Insert attachment arm into socket
3
at back of Satellite.
Attachment arm.
Mount the rear Satellites only on walls that are structurally sound.
Position the Satellites behind you and slightly above ear level.
1 Drill a hole about 2 cm
(1 inch) deep into wall.
2 Tap plastic anchor into hole
until it is flush with wall.
Screw a M5 x 25 mm screw
3
into anchor, leaving about
0.5 cm (¼ inch) protruding.
5 Slip keyhole slot of each
rear Satellite onto protruding
screw.
Apply rubber
4
pads on the
back of each
rear Satellite.