Murray EV3850x4NA Instruction Book page 7

HOW TO RAISE THE HANDLE
1. Loosen the knobs and raise the upper
handle to the upright position. See
Figure 2.
2. Tighten the knobs. Make sure the
knobs are to the outside of the handles
as shown in Figure 2.
3. Insert the end of the control rod, from
RIGHT to LEFT, through the hole in the
front wheel arm. Attach with hair pin
found in parts bag. See Figure 3.
4. Push down on the handle to tilt the unit
back.
Knobs
Control
Rod
Front
Wheel Arm
Control
Rod
F–041105C
ASSEMBLY
Upper
Handle
Figure 2
Hair Pin
Figure 3
5. Insert the other end of the control rod,
from RIGHT to LEFT, through the hole in
the depth control lever and fasten with
hair pin. See Figure 4.
6. Move the depth control lever forward to
the STARTING and TRANSPORT posi-
tion.
7. Remove any packing material from the
bottom of the unit.
8. To attach the recoil starter rope to the
rope guide, twist the recoil starter rope
through the rope guide. See Figure 5.
Hairpin
Depth Control
Lever
Control Rod
Rope Guide
Recoil Starter
Rope
7
Figure 4
Figure 5