Advertisement
Available languages
Available languages
1800133852 DG8510-20 U0_110x154 26/06/14 15:29 Page13
Problems
Water streaks appear on
the linen.
White streaks come
through the holes in the
soleplate.
Brown streaks come
through the holes in the
soleplate and stain the
linen.
The soleplate is dirty or
brown and may stain the
linen.
There is no steam or there
is little steam.
Steam comes out from
around the collector
cover/boiler rinse cap
(according to model).
The red "water tank
empty" light flashes.
Steam or water escapes
under the appliance.
The orange "Calc- way
System" or "Boiler rinse"
(according to the model)
light is flashing.
Possible Causes Solutions
When taking a break from
ironing, if your ironing
board cover is soaked with
water it is not suited to the
power of a steam station.
Your boiler has a build-up
of scale because it has not
been rinsed out regularly.
You are using chemical
descaling agents or
additives in the water for
ironing.
You are ironing at too high
a temperature.
Your linen is not rinsed
sufficiently or you have
ironed a new garment
before washing it.
You are using starch.
The water tank is empty
(red light flashing).
The soleplate temperature
is set to the maximum.
The water tank is not
correctly fitted into its
housing.
The collector/cap (according
to model) is not tight
enough.
The seal of the
collector/cap (according to
model) is damaged.
The station is faulty.
You did not press the
"Restart" button.
The station is faulty.
You did not press the
"Restart" button.
13
Check that your ironing board is suitable.
mesh type ironing board must be used
avoid condensation.
Depending on model:
- Rinse the collector when the "Calc- way
System" indicator flashes.
- Rinse the boiler when the ""Boiler rinse"
light flashes.
If your water is very hard, rinse it more
often.
Never add this type of product to the water
tank (see § 2).
Contact an pproved Service Centre.
See our recommendations regarding
temperature control setting.
Ensure linen is rinsed thoroughly to remove
any soap deposits or chemicals on new
garments which may be sucked up by the
iron.
ways spray starch on the reverse side of
the fabric to be ironed.
Fill the water tank and press the "Restart"
button on the control panel.
The station is working but steam is very hot
and dry. s a result, it is less visible.
Push it into position until it "clicks" into
place.
Tighten the collector/cap after having let the
appliance cool for 2 hours.
Contact an pproved Service Centre.
Stop using the station and contact an
pproved Service Centre.
Press the "Restart" button on the control
panel until the indicator goes out.
Stop using the station and contact an
pproved Service Centre.
Press the "Restart" button on the control
panel until the indicator goes out.
EN
Advertisement
