Indication Lamp - Makita DTM40 Instruction Manual

1
012779
Slide the slide switch toward the "I (ON)" position to light up
the front lamp. The lamp keeps on lighting while the switch is
the "I (ON)" position. The light automatically goes out after
pressing the rear of the slide switch, and then sliding the slide
switch toward the "O (OFF)" position.
Overload protection
When the tool is overloaded and the tool temperature
reaches a certain level, the front lamp blinks and the tool
automatically stops. Remove a cause of overload to restart.

Indication lamp

1
012771
When the remaining battery capacity gets low, the
•
indication lamp blinks.
When the remaining battery capacity gets much
•
lower, the tool stops during operation and the
indication lamp lights up about 10 seconds.
At this time, remove the battery cartridge from the tool
and charge it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing application tool
(optional accessory)
WARNING:
Do not install application tool upside down.
•
Installing application tool upside down may damage
the tool and cause serious personal injury.
Install attachment tool in the correct direction
•
according to your work. Application tool can be
installed at an angle of every 30 degree.
1. Front lamp
1. Indication lamp
7
1
2
3
012826
2
1
3
012767
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the
application tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction, mount
a sanding paper so that the holes in a sanding paper
match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application tool.
1
2
3
4
012847
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
1. Application tool
installation bolt
2. Holes in the
application tool
3. Protrusions of
the tool flange
1. Application tool
installation bolt
2. Hex wrench
3. Tighten
1. Application tool
installation bolt
2. Holes in the
application tool
3. Adapter (required
for some
application tools)
4. Protrusions of
the tool flange