Heater - Lake Powell 54 ESCAPE Instruction Manual

HEATER

On
Propane Heater
• Turn ON DC MAIN breaker on the
DC panel.
• Turn ON the Furnace breaker on the
DC panel.
• Be certain that the propane is on.
• Set thermostat to desired
temperature.
• The fan will come on and run for 2-5
minutes before you feel heat come
out of the vents.
Heat Pump
• Turn the circuit breaker on the
electrical panel for the AC on.
• Adjust the thermostat (the larger of
the two) to the desired temperature.
Do not set the thermostat lower
than 72 degrees.
• Set the control at the bottom to the
heat setting.
COMMON TROUBLESHOOTING
PROBLEM
Heater won't light
Heat pump won't
work
21
Off
• At thermostat, move white switch at
• Turn OFF HEATER breaker at DC
• The fan will continue to run for 2-3
POSSIBLE CAUSES
DC main is Off
Heater breaker is off
Thermostat is off
Low battery
Thermostat not set to
heat.
Breaker not turned on.
button to OFF.
panel.
minutes after you have shut down
the heating system.
REMEDIES
Turn on DC MAIN
Turn on the HEATER
breaker
Turn on the thermostat
Charge the battery
Set control to heat setting.
Turn breaker on.