Table of Contents
Advertisement
3.
The first two digits on the LCD represent the
month (MM) and last two digits represent day
(DD).
4.
Press UP or DOWN to select month between 01-
12 and press OK to confirm.
5.
Press UP or DOWN to select day between 01-31
and press OK to confirm.
6.
Press UP or DOWN to select year between 00-99
(2000-2099) and press OK to confirm.
7.
Press SETUP to save and exit.
t
IMe
1.
Enter setup mode as described on page 8. The
LCD will flash "DATE".
2.
Press UP or DOWN until #2 "TIME" is blinking
and press OK.
3.
The first two digits on the LCD represent hours
(HH) and last two digits represent minutes (MM).
4.
Press UP or DOWN to select the hour between
00-23 and press OK to confirm.
5.
Press UP or DOWN to select minutes between
00-59 and press OK to confirm.
6.
Press SETUP to save and exit.
▲
In order to conserve battery power during
storage the date and time will reset to zero if
the unit is switched off for more than an hour.
Remember to reset the date and time whenever
you set the camera up.
▲
Remove batteries if the camera is to remain
unused for a long period of time.
- 11 -
Advertisement
Table of Contents
