Advertisement
3.1.9 REAR PANEL
(1) Remove 8 screws [A].
(2) Remove 4 screws [B].
(3) Take out the REAR PANEL.
NOTE :
• Before the rear panel is inserted into the cabinet, release the
short-circuit between the [SB] connector [1] and [2] pin of the
DIGITAL INPUT MODULE PWB. (Refer to "CAUTION AT
DISASSEMBLY" on Page 10).
• After releasing the short circuit between the [SB]
connectors, do not turn the power on until the rear panel is
inserted into the cabinet.
• Prior to starting the work, be sure to read the following
written instructions on the CAUTION LABEL attached to the
REAR PANEL.
3.1.10 PARTITION
• Take out the REAR PANEL.
(1) Pull out the PARTITION backward.
Prior to starting the work, be sure to read the following
written instructions on the CAUTION LABEL attached to
the REAR PANEL.
UNPLUG THE POWER CORD FROM AC OUTLET BEFORE
OPEN THE REAR PANEL.
When the rear panel is removed, follow "CAUTION AT
DISASSEMBLY" procedure in the service manual before
plugging the TV's power cord into an AC outlet.
Failure to follow the procedure will result in PERMANENT
damage to some of the television features.
3.1.11 REAR COVER
• Take out the SPEAKER GRILLE.
• Take out the FRONT CONTROL BOX.
• Take out the SCREEN ASS'Y.
(1) Remove 2 screws [ C ].
(2) Remove 2 screws [ D ] from front side.
(3) Slightly pull for backside to disengage of the REAR COVER
from hooks.
(4) Take out the REAR COVER.
NOTE :
• Because of the large size, at least 2 persons are
recommended for removal and reassemble.
1-12 (No.YA173)
REAR COVER
PARTITION
A
(x8)
CAUTION LABEL
B
(x4)
Fig.5
REAR COVER
C
(x2)
HOOK
Fig.6
FRONT
BODY
REAR PANEL
FRONT
D
(x2)
D
BRACKET
BODY
Advertisement
