Advertisement
3.1.6 SCREEN ASS'Y
• Take out the SPEAKER GRILLE.
• Take out the FRONT CONTROL BOX.
(1) Disconnect the connector [CN00Z].
(2) Remove 4 screws [A] attaching the SCREEN ASS'Y.
(3) Remove 10 screws [B] from rear side.
(4) Take out the SCREEN ASS'Y.
NOTE :
• Please place the SCREEN ASS'Y on a flat table without fail.
• Because of the large size, at least 2 parsons are
recommended for removal and reassemble.
• Use core not to scratch the screen during work.
• During assembly, be sure to engage the left and right tabs
with the cabinet mounting positions.
• When than supporting the SCREEN ASS'Y, avoid grasping
the top of the screen panel, instead grasp the left and right
areas.
3.1.7 CONVERGENCE SENSOR
• Take out the SPEAKER GRILLE.
• Take out the FRONT CONTROL BOX.
• Take out the SCREEN ASS'Y.
(1) Remove the 1 screw [C] attaching the SENSOR HOLDER.
(2) Remove the claw of the SENSOR HOLDER to take out the
CONVERGENCE SENSOR.
(3) Take out the 3 others CONVERGENCE SENSOR same
manner.
3.1.8 MIRROR
• Take out the SPEAKER GRILLE.
• Take out the FRONT CONTROL BOX.
• Take out the SCREEN ASS'Y.
(1) Remove 9 screws [D] attaching the mirror brackets of the
upper, left and right side.
(2) Raise slightly to disengage of the mirror from the bottom
bracket. (If necessary, loosen the screws attaching the
bottom bracket)
(3) Take out the MIRROR.
NOTE :
• The MIRROR is front coated.
Do not touch the front of the MIRROR.
• At least 2 persons are recommended for removable and
reassemble.
(Front view)
A
(x4)
B
(x10)
REAR COVER
Fig.2
SENSOR
HOLDER1
CLAW
CONVERGENCE
SENSOR
CONNECTOR
CONVERGENCE
SENSOR
C
(x4)
Fig.3
FRONT
MIRROR
D
(x9)
MIRROR BRACKET
Fig.4
SCREEN ASS'Y
FRONT
CN00Z
BODY
SCREEN ASS'Y
FRONT
SENSOR
HOLDER2
SENSOR
HOLDER1
REAR COVER
BRACKET
BODY
(No.YA173)1-11
Advertisement
