GLOBAL ASSISTIVE DEVICES VibraLITE 3 Instruction Manual page 2

minutes. You cannot switch to another mode of operation while the display is blinking. To
exit and stop the blinking, push LAP/RESET button.
1. Repeat pressing the MODE button until the CALENDAR CLOCK operating mode
shows on the display.
2. Press & Hold the LAP/RESET button until the second‟s digits begin to BLINK.
Press the START/STOP button to reset the second‟s display to 00.
3. Press the MODE button. The hour digits will begin to BLINK.
Press the START/STOP button to rotate to correct hour of the day.
WHEN IN THE 12 HR MODE, A PM INDICATOR
WILL APPEAR ON THE DISPLAY ABOVE AND
LEFT OF THE HOUR DIGITS. AS YOU ROTATE
TO 12 HOURS THE PM MUST SHOW FOR
SETTING CORRECT TIME FOR AFTERNOON
OR EVENING. BE SURE TO SET CORRECTLY
FOR THE CURRENT TIME OF DAY.
4. Press the MODE button to go to the minute digits. The minute digits will begin to
BLINK.
Press the START/STOP button to rotate to the correct minute.
5. Press the MODE button and the 12H or 24H will show and BLINK on the display.
Press the START/STOP button to change from 12H to 24H or from 24H to 12H.
6. Press the MODE button for the date of the month. A number will BLINK at the top left
corner of the display. Press the START/STOP button to rotate to the correct date of the
month. (1 - 31)
7. Press the MODE button for the Month. A number will BLINK on the display. Press the
START/STOP button to rotate to the current month of the year. (Example; 6 for Jun, 9
for Sept)
8. Press the MODE button for the Day of the Week. A two-letter abbreviation at the top of
the display will BLINK. Press the START/STOP button to rotate to the correct day.
(Example TU for Tuesday; TH for Thursday)
9. Press the LAP/RESET button when you have finished the correct set up. The display
will stop blinking.
HOW TO SET AN ALARM CLOCK (Setting procedure is the same for BOTH alarms)
1. Repeat Pressing the MODE button to rotate to the alarm operating mode you want: A1
= 1st ALARM or A2 = 2ND ALARM.
2. Press & Hold the LAP/RESET button until the hour digits BLINK.
Press the START/STOP button to rotate to the hour wanted.
Note: In the 12 Hr Mode, remember to use the PM indicator for correct setting.
3. Press the MODE button to go to the minutes. The minutes will BLINK. Press the
START/STOP button to rotate to the minute wanted.