Operation - Cameo CLFLOWERHP User Manual

OPERATION:

DMX CONTROL AND ADJUSTMENT OF DMX START ADDRESS
Press the MODE button repeatedly until the LED indicator lights up and
displays the DMX start address on the display (A001 - A512). The DMX start
address can be adjusted as desired by using the UP and DOWN buttons. The
synchronous control of several projectors of the same model through a DMX
controller (eg DMX console) can be achieved by adjusting the projectors on
an identical DMX-starting address and connecting them using DMX cables.
CONVERSION OF THE DMX MODE
The projector has a 2-channel and 5-channel mode. If you want to switch
between these two modes, press the MODE button repeatedly until they
reach the address selection (A001-A512). To enter the submenu, select the
DMX mode and press the ENTER button. Depending on the operating mode,
either "CH02" (2-channel mode) or "CH05" (5-channel mode) will appear on
the display. Use the UP and DOWN buttons to select the desired DMX mode.
SLAVE
Press the MODE button repeatedly until the LED indicator lights up and
displays "SLAV" on the display. Once the slave unit has been connected to
the master unit (same model) with the help of a DMX cable (Master = DMX
OUT, Slave = DMX IN), and the master unit has been set to one of the stan-
dalone modes (automatic control or music control), the slave unit follows the
master unit. There is no need for selecting a special setting on the master
unit, since the device operates automatically as the Master for both Auto and
Music Control modes.
AUTOMATIC CONTROL
Press the MODE button repeatedly until the LED indicator lights up and
displays "AUTO" on the display. To change the speed of the automatic mode,
press the ENTER button.
MUSIC CONTROL
Press the MODE button repeatedly until the LED indicator lights up and
displays "SUxx" on the display. Using the UP and DOWN buttons, adjust the
sensitivity (SU00 - SU99).
9