Sony SA-SPC5 Operating Instructions Manual

Additional Information

Specifications

For the U.S.A. model
Main Speaker
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 4 ohm lord driven. from 100 Hz – 20 kHz; rated
15 watts minimum RMS power, with more than 9 %
total harmonic distortion from 250 mW to the rated
output.
Amplifier Section
Power output
Input sensitivity/Impedance
Tone control
Speaker Section
Type
Speaker unit
Frequency range
General
Power requirement 120 V/60 Hz
Power consumption Left: 17 W
Dimensions
Mass
Supplied accessories Audio connecting cord
Sony Corporation
Printed in Malaysia
15 W + 15 W (4 ohms at 100 Hz – 20 kHz,
9 % THD)
–10 db, 10 kilohms
Low-Boost: 0 – +6 db at 80 Hz
Hi-Boost: 0 – +6 db at 15 kHz
Bass reflex type
10 cm cone type
70 Hz – 20 kHz
Right: 17 W
Left: Approx. 132 × 210 × 245 mm
× 8 × 9
1 3 3
(w/h/d) (5 / / / inches)
4 8 4
Right: Approx. 132 × 210 × 245 mm
× 8 × 9
(w/h/d) (5 1 / 3 / 3 / inches)
4 8 4
Left: Approx. 3.4 kg (7 Ib 8 oz)
Right: Approx. 3.3 kg (7 Ib 4 oz)
1 phono plug – 1 phono plug monaural
(1.5 m) × 1
1 phono plug – 1 phono plug monaural
(2 m) × 1
2 phono plug – 1 mini plug stereo
(1.5 m) × 1
Super Woofer
AUDIO POWER SPECIFICATIONS POWER OUTPUT
AND TOTAL HARMONIC DISTORTION:
With 2 ohm lord driven, from 50 Hz – 250 Hz; rated
27 watts minimum RMS power, with more than 9 %
total harmonic distortion from 250 mW to the rated
output.
Amplifier Section
Power output 27 W (2 ohms at 50 Hz – 250 Hz,
9 % THD)
Input sensitivity/Impedance
–10 db, 10 kilohms
Tone control Low-Boost: 0 – +6 db at 50 Hz
Frequency adjust range of High cut-off
80 Hz – 250 Hz
Speaker Section
Type Bass reflex type
Speaker unit 13 cm cone type
Frequency range
50 Hz – 250 Hz
General
Power requirememt 120 V/60 Hz
Power consumption 28 W
Approx. 267 × 210 × 294 mm (w/h/d)
Dimensions
× 8
(10 5 / 3 /
8
Mass Approx. 6.6 kg (14 Ib 9 oz)
Design and specifications are subject to change without
notice.
× 11
5 / inches)
8 8