On-Screen Language Selection; Channel Setup; Programme Edit; Basic Operation - Sharp LC-24LE440M Operation Manual

On-screen Language
Selection
1
Press MENU (unless you have already selected
when the set was fi rst switched on). Then press
c / d to select "Setup", then press b or ENTER.
OSD Language
TT Language
OSD Timer
Reset
2
Press a / b to select "OSD Language", then
press c / d to select the desired language.
3
Press RETURN to exit the menu.

Channel setup

Press MENU. Select "Channel/ATV Manual Tuning",
then press d or ENTER.
Press a / b to select desired item, then press
c / d to setting.
Channel
Current CH:
Color System
Sound System
Search
AFC
Fine-Tune
Skip
Current CH: Set the channel number.
Color System: Select the color system. Colour
System has already been preset to automatic. Do not
change anything here. Any changes can cause picture
or sound disruption.
Sound System: Select the sound system. The correct
sound system is already installed. Any changes can
cause sound disruption.
Search: Press c to search down from the current
frequency, and press d to search up.
AFC: Automatic Fine Tuning.
Fine-Tune: Adjust the frequency of the channel fi nely.
Skip: Select "On" to skip the current channel when
you select the channel by pressing P+/P-.
Press RETURN to exit the menu.
8
J3NC0101C_EN.indd 8 J3NC0101C_EN.indd 8
Setup
< English >
< West >
< 20 Sec >
>
-
< 2 >
< NTSC >
< M >
< 67.25MHz >
< On >
>
< Off >

Programme Edit

You can preset your favorite channel (Channel List).
Press MENU. Select "Channel/Program Edit", then
press d or ENTER.
Program Edit
001 011
002 012
003 013
004 014
005 015
006 016
007 017
008 018
009 019
010 020
Rename Delete
Rename (red button): You can input or change the
name of a channel on the cursor screen with a / b / c /
d , ENTER and red buttons.
Delete (green button): Press green button to select
the desired channel, then you can delete channel when
press red or ENTER buttons.
Move (yellow button): Press a / b / c / d to select
the position that you want to swap the channel with,
then press red or ENTER buttons.

Basic Operation

Channel selection
With the Numbered buttons (0-9).
Example:
• No. 2: Press 2.
• No. 29: Press 2 and within 2 seconds, press 9.
• No. 929: Press 9, 2, 9 same as above.
Press P +/- to change up or down a channel. This
takes approx. 2 seconds. If the auto search only stored
5 stations, only these 5 will appear. Skipped channels
will not appear.
Channel List
The Channel List shows a list of all receivable
programmes.
Press CH LIST to display the Channel List.
Press a / b / c / d to select the desired channel.
Press CH LIST to display the selected channel.
NOTE
• To display the programmes on the channel list, it is
necessary to input the programme name in "Program Edit"
mode.
021
022
023
024
025
026
027
028
029
030
Move
5/27/2013 1:48:47 PM 5/27/2013 1:48:47 PM