King Canada KCG-6500GE Instruction Manual

King Canada KCG-6500GE Instruction Manual

6500w gasoline generator

Advertisement

6500W GASOLINE GENERATOR
WITH ELECTRIC START
Read this manual. Do not attempt to operate this generator until you have
read and understood the safety, operation, and maintenance instructions
MODEL: KCG-6500GE
INSTRUCTION MANUAL
COPYRIGHT © 2007 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.

Advertisement

Table of Contents
loading

Summary of Contents for King Canada KCG-6500GE

  • Page 1 WITH ELECTRIC START Read this manual. Do not attempt to operate this generator until you have read and understood the safety, operation, and maintenance instructions MODEL: KCG-6500GE INSTRUCTION MANUAL COPYRIGHT © 2007 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
  • Page 2: Warranty And Service Information

    KING CANADA shall in no event be liable for death, injuries to persons or property or for incidental, special or consequential damages arising from the use of our products. Shipping and handling charges may apply. If a defect is found, KING CANADA will either repair or replace the product.
  • Page 3 BASIC & SPECIFIC SAFETY PRECAUTIONS BE CAREFUL! DO NOT USE KEEP FLAMMABLE DO NOT USE IN DO NOT CONNECT TO IN YOUR HOUSE WET CONDITIONS HOUSEHOLD CIRCUIT MATERIALS AWAY WHEN REFUELING; STOP ENGINE! NO SMOKING! DO NOT SPILL GASOLINE! BASIC SAFETY INFORMATION touching the engine or muffler while they are still hot.
  • Page 4: Specific Safety Precautions

    SPECIFIC SAFETY PRECAUTIONS OPERATION OF GENERATOR IN RAIN, WET, ICY, OR FLOODED RISK OF BREATHING - INHALATION HAZARD CONDITIONS. Operate generator in clean, dry, well ventilated area. Never operate Water is an excellent conductor of electricity! Water which comes in unit in enclosed areas such as garages, basements, storage, sheds, or contact with electrically charged components can transmit electricity to in any location occupied by humans or animals.
  • Page 5: Getting To Know Your Generator

    13. Voltmeter. Indicates the voltage rating. 22. Air cleaner filter/cover. Periodically the air cleaner filter must be 14. Duplex AC 120V outlets. Plug up to 2-120V appliances or a power checked and maintained, see maintenance section. MODEL KCG-6500GE Peak Wattage (starting) 6500W Running Wattage 5500W AC Outputs 3(2x 120V/45.8A)(1x 240V/22.9A)
  • Page 6: Inspection Before Operation

    INSPECTION BEFORE OPERATION WARNING! You MUST check battery position and connections, oil level, fuel level, air cleaner filter and unplug any load from the generator before starting generator to prevent permanent damage to any appliances. 12V Battery for Electric Start Important Note: Before connecting electrical wires to the battery, it is very important to make sure the generator engine switch is off and that there are no electrical loads connected to generator.
  • Page 7 STARTING/STOPPING YOUR GENERATOR BEFORE STARTING YOU GENERATOR- IT MUST BE GROUNDED FIRST! GROUNDING Before operating make sure to ground the generator. A ground terminal identified by the ground symbol can be found on the front control panel of the generator, attach a metal spike to a wire, attach the wire to the ground terminal and ground the metal spike into the earth.
  • Page 8: Electrical Connections

    Overloading the generator will cause power fluctuations and can damage equipment and appliances. King Canada will only be responsible for damage to customer's equipment when the generator is determined to be defective. King Canada will not be responsible for equipment damaged as a result of voltage surges, improper operation or improper installation of the generator.
  • Page 9 WATTAGE CALCULATIONS WATTAGE CALCULATIONS DETERMINING WATTAGE REQUIREMENTS Note: Volts X Amps = Watts IMPORTANT! Never exceed the rated capacity of your generator. Serious damage to the generator or appliance could result from an Example: 120V X 10 Amps = 1200 Watts overload.
  • Page 10: Maintenance And Storage

    MAINTENANCE & STORAGE Maintaining your generator Engine Oil Replacement Engine oil should be replaced the first 20 hours of operation or the first month of use, it should be replaced every 100 hours or 6 months after. To replace engine oil; 1) Loosen the oil gauge dipstick (A) Fig.9.
  • Page 11: Troubleshooting

    2. Faulty windings in field coil. 2. Have Service Center replace. 3. Faulty wire harness. 3. Have Service Center replace. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.

Table of Contents