Maintenance - Ryobi CNS-1801M User Manual

GB
F D
OPERATION
LOADING THE TOOL WITH STAPLES (Fig. 3-4)
Remove battery pack from the tool.
■
Hold tool upside down; squeeze tabs and slide
■
base open.
Place staples in channel, legs facing upward and
■
close base.
Make sure the tabs are securely locked in place.
■
Reattach battery pack to tool.
■
LOADING THE TOOL WITH BRADS (Fig. 3-5)
Remove battery pack from the tool.
■
Hold tool upside down; squeeze tabs and slide
■
base open.
Place brads in the centre of the channel with "T" head
■
sitting on the slot base. Close base while making sure
brad strip stays upright in channel.
Note: There are two channels for the brads. Use the
smaller channel for brads sized 3/4 in. to 1 in. Use the
larger channel for brads sized 1-1/4 in. Refer to
molding on the tool.
Make sure that the tabs are securely locked in place.
■
Reattach battery pack to tool.
■
SETTING DEPTH (Fig. 6)
Rotate the depth adjustment knob clockwise to use
■
more force for nailing or stapling.
Rotate depth adjustment knob counter clockwise to
■
use less force for nailing or stapling.
Test on a scrap piece of the same material you are
■
using to achieve the desired results.
Note: Harder materials will require more force to nail
or staple.
NAILING OR STAPLING (Fig. 7)
Hold handle firmly with magazine flat to workpiece
■
forming a 90º angle.
Press the activation foot of the nailer/stapler down
■
against the workpiece to disengage the safety
interlock. The activation foot must be depressed
before the switch trigger is depressed.
Release the trigger switch and activation foot before
■
driving another brad or staple.
Note: You must release the activation foot and switch
trigger after each brad or staple to reset the tool.
The tool will not fire another staple or brad until the
activation foot and trigger switch are released.
E I P NL S DK N FIN GR
English
REMOVING A JAMMED BRAD/STAPLE
Remove battery pack from the tool.
■
Hold tool upside down; squeeze tabs and slide
■
base open.
Remove unused brads/staples from magazine.
■
Remove jammed brad/staple with needle nose pliers.
■
Note: You must remove jammed brad/staple before
using tool any further. If you try to fire a brad/staple
while the tool is jammed, you could cause damage to
the mechanism.

MAINTENANCE

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
Only the parts shown on the parts list are intended to be
re-paired or replaced by the customer. All other parts
should be replaced at a Authorized Service Center.
7
RO
H CZ RUS
WARNING
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
WARNING
To avoid serious personal injury, always remove
thebattery pack from the tool when cleaning or
performing any maintenance.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken ordestroy plastic which may
result in serious personal injury.
HR
PL SLO TR