Table of Contents
Advertisement
⑩
Fig.4
Fig.5
②
①
7
Fig.6
④
Fig.7
2.2.2 Mounting binocular head (Fig.3)
Loose the clamping bolt⑦ on the pillar⑥
and insert the binocular head and zoom body
assembly⑧into the bracket of the pillar, then
screw down the bolt⑦.
2.2.3 Mounting eyepieces (Fig.3 Fig.4
Fig.5)
1. Remove the eyepiece dust caps⑨ and gently
insert two adjustable eyepieces ⑩ into the
eyepiece sleeves until they stops, as in Fig.4.
2. Using the Eye Shades
When Wearing Eyeglasses:
Use with eye shades in their normal
folded-down position. This will prevent
eyeglasses from being scratched by the eyepiece
as in Fig 5.
When Not Wearing Eyeglasses:
Extend the folded eyeshades. This makes
observation easier by preventing the inverse
incidence of light from between the eyepiece and
your eyes.
2.2.4Connecting the power cord (Fig.6)
1. Turn the main switch① on "O" (off) state
③
before connecting the power cord.
2. Insert the power plug② into the power jack
of the microscope; make sure the connection
is well.
3. Plug the power cord ③ into the power
supply receptacle safely. Make sure the
connection is well.
2.2.5 Mounting glass stage plate (Fig.7)
If necessary, the original plastic stage
plate can be replaced by a glass one.
● Both top and bottom illuminators are LEDS.
● Permitted power supply voltage：
100V～240V。
7
,
,
Advertisement
Table of Contents
