Tilting Work Surface; Cleaning - Black & Decker Workmate 79-020 Owner's Manual

TILTING the WORK SURFACE
The t o p o f t h e W O R K M AT E ® m a y b e
tilted t o 1 5 ° , 3 0 ' o r 4 5 ° f o r u s e i n c r a f t
or h o b b y w o r k s u c h a s w o o d b u r n i n g
(Figure 15), c a r v i n g l i n o l e u m b l o c k s , e t c .
To tilt the W O R K M AT E * top:
FIG. 15
1. C l a m p t h e W O R K M AT E * t o t h e b e n c h
with t h e v i s e h a n d l e s a t t h e b a c k o f
the W O R K M AT E ® ( f a c i n g t h e b a c k o f
the work bench) (Figure 16).
2. L o o s e n t h e Wing Screws on both sides
of t h e W O R K M AT E ® .
FIG. 1 6
I . 4 1 7 . 1 8 - - - 4 - 4 1 - k
WING
SCREW
3. Ti l t the t o p so that the inside ends of
the Wing Screws will fully seat in one
of t h e t h r e e optional angular, d e t e n t
positions (Figure 17).
4. Retighten S c r e w s f i r m l y.
CAUTION: D o n o t l o a d t h e W O R K M AT E "
with m o r e than 4 0 pounds when i t i s i n a
tilted position.
To u s e t h e W O R K M AT E ® a s a d r a w i n g -
board s u p p o r t (Figure 1 8 ) , fasten a s t r i p
of w o o d a b o u t 11 / 2 " o r 13/4" t h i c k a n d
about 1 6 " l o n g t o o n e o f t h e s m a l l e r
sized standard d r a w i n g -boards. T h i s s t r i p
should b e centered o n the horizontal c e n -
terline o f t h e b a c k o f t h e b o a r d . P l a c e
this s t r i p b e t w e e n t h e v i s e j a w s a n d
tighten t h e handles.

CLEANING

Use o n l y s o a p a n d w a t e r t o c l e a n t h e
W O R K M AT E . D r y m e t a l p a r t s t h o r -
oughly.
6
1 0 . •
L I M O N /
15'' 30° 4 5 '
FIG. 17
FIG. 18