Table of Contents
Advertisement
remote Head
nut
washer
threaded
rod
bulkhead
Feed the connecting cable through the centre hole then align
the 4 threaded rods with the mounting holes. Fasten from
behind the panel using the 4 stainless steel washers and
M3 nuts.
G - D E K
i n S t r u C t i o n M a n u a l
FlusH mount usinG adHesive taPe
Feed the cable through the centre hole in the panel then peel
the remaining backing from the adhesive tape and carefully
position the remote head against the panel, ensuring it is level.
the adhesive is pressure sensitive so press firmly and hold for
several seconds to allow the adhesive to grip.
mountinG tHe multimedia Hub
the multimedia hub can be mounted in almost any convenient
location however it should be protected from sunlight and
water spray where possible. the multimedia hub contains inputs
for your SD card, uSB memory stick, iPod/iPhone and generic
MP3 player so you will need to be mounted it in a location
where it can be accessed such as inside the cabin of
your vessel.
the multimedia hub can be fixed to any flat surface using
screws or bolts via the four mounting points provided. the
mounting location should be free from direct sunlight, water
and excessive vibration and there should be sufficient room
to open the cover. When fully opened, the cover will latch into
place and will maintain its position no matter what the angle
of installation.
Clean these
surfaces and
apply adhesive
tape
Pa G E 1 2
Hide quick links:
Advertisement
Table of Contents
