Risk Of Electric Shock - Dura Heat EUH4000R Installation Instructions And Operators Manual

Grounding Instructions:
This heater is for use on 240 (208) volt circuits. The cord has a plug as shown below. No adapter is available for
this blade Configuration, and none should be used. The type outletIs a 240 (208) volt grounding outlet. When
properly installed It provides a ground connection through the cord to the heaterto prevent the operator from
electric shock.
Be sure that the electrical receptacle is of the configuration and capacity appropiate for the heater.
Automatic Overheat Safety Control
• This heater is equipped with and internal heat limiting thermostat and overheat protection circuit.
When a potential overheat temperature is reached, the system will automatically shut the heater off.
• IF SAFETY LIMIT LIGHT ILLUMINATES an abnormal condition has turned off the heating elements. TO
RESET WAIT 10 MINUTES to allow the heater to cool down, the heater will automatically reset once
the heating element cools down.
Cleaning and Maintenance
Any electrical repairs or rewiring of this unit should be carried out by a licensed electrician and
• Before cleaning the appliance, disconnect it from the power outlet and let it cool down.
• In order to protect the enclosure, don't splash water onto the heater, and never use a solvent like
gasoline, isoamyl acetate, toluene, etc. to clean the heater. DO NOT open the heater or attempt to
clean the inside of this appliance.
CAUTION:

RISK OF ELECTRIC SHOCK

DO NOT OPEN
NO SERVICEABLE PARTS INSIDE
accordance with national and local codes.
~ 7 ~