Table of Contents
Advertisement
3
EFFECT MODES CHART
This chart shows you what 256 effect modes
are in the TFX256 PRO.
4
LED DISPLAY
This 7-segment display indicates the current
effect program in Program mode. When the
display shows the letter "C" flashing, this
means either the right or left input signals are
too high and should be reduced.
5
PROGRAM SELECT KNOB
Turning this control will allow users to 'preview'
the different digital effects. Pushing it in will load
the preset. If this control is not pushed within a
few seconds of changing the effect, the TFX256
PRO will automatically revert back to the previ-
ously loaded effect. When this control is held
down for a few seconds, the digital effects b will
be bypassed. Holding it down again will reacti-
REAR-PANEL DESCRIPTION
9
LOAD INDICATOR
This small LED indicator, located within the digital
effect display, will flash when users are previewing
different effects (when turning the program select
knob). When a new program is loaded, this LED
will stop flashing.
10
AC 10V IN INLET
The supplied AC Adapter is plugged into this
connector.
11
FOOTSWITCH
This is a 1/4" stereo phone jack. If a foot switch
is connected to this jack, you can use your foot
vate the effects.
6
OUTPUT LEVEL CONTROL
This rotary control sets the level going to the amplifier
or mixer from the output of the TFX256 PRO
7
POWER SWITCH
This switch turns the power of the TFX256 PRO on/off.
Whenpower is off, the TFX256 PRO will be in signal
bypass position automatically i.e. this feature allows
the direct signal to pass through the TFX256 PRO
even when the power is not switched on.
8
SIGNAL INDICATORS
These 2 small LED indicators, located within the digital
effect display, show when either the left or right inputs are
receiving a signal (the left LED indicates when the left
input is receiving a signal, the right indicates when the
right receives a signal). When the LCD display (above
these indicators) flashes "C", the signal in the left or right
channel is excessive, and should be reduced to keep the
audio's integrity.
to switch the effect mute on/off (bypass).
12
OUTPUT (LEFT & RIGHT)
There are 1/4" phone jacks which connect to
devices such as the effects returns on a mixing
console or power amplifier inputs. For mono
applications, use the "Left" output.
13
INPUT (LEFT/MONO & RIGHT)
There are 1/4" phone jacks which connect to
sources such as the effects sends of mixing
consoles. For mono applications, use the "Left/
Mono" input.
TFX256 PRO USER'S MANUAL
REAR-PANEL DESCRIPTION
Page 5
Advertisement
Table of Contents
