Fujitsu ASYA09LEC Design & Technical Manual page 24

CONTENTS OF FUNCTION SETTING
• Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
• The settings may be selected between the following two: Function Number or Setting Value.
• Settings will not be changed if invalid numbers or setting values are selected.
1-1 Cooler room temperature correction
1-2 Heater room temperature correction
1-3 Auto Restart
1-4 Indoor Room Temperature Sensor
1-5 Remote controller Signal Code
1-1. Setting the Cooler Room Temperature Correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
Setting Description
Standard
Lower control
1-2. Setting the Heater Room Temperature Correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
Standard
Lower control
Slightly warmer control
Warmer control
Mounted
( . . .Factory setting)
Function Number Setting Value
30
( . . .Factory setting)
Function Number Setting Value
31
- (01 - 21) -
Wall
●
●
●
●
●
00
01
00
01
02
03