Table of Contents
Advertisement
Controls and Features
Drive Control
Chute Assembly
Oil Fill
Clean Out
Tool
Augers
Snow thrower controls and features are described below and
illustrated in Fig. 4-1.
Shift Lever
The shift lever is located in the right side of the
handle panel and is used to determine ground
speed and direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
Gas Cap
Skid Shoe
Figure 4-1
Shift Lever
Chute Directional Control
Auger Control
Heated Grips*
Mu er
Primer
Ignition
Key
Throttle
Control
Choke
Control
Oil Drain
Electric Starter Outlet
Choke Control
The choke control is found on the rear of
the engine and is activated by rotating the
knob. Activating the choke control closes
the choke plate on the carburetor and aids
in starting the engine.
Ignition Key
The ignition key is a safety device. It must
be fully inserted in order for the engine to
start. Remove the ignition key when the
snow thrower is not in use.
Note: Do not turn the ignition key in an
attempt to start the engine. Doing so may
cause it to break.
4
Recoil Starter
Handle
Electric Start
Button
11
Advertisement
Table of Contents
