Hummer 2009 H3 Getting To Know Manual page 14

112106_09a_Hummer_H3_GTK_051408.qxd:H3 2007 A
Getting to Know Your H H 3 3 / / H H 3 3 T T
1 1 4 4
S S w w i i n n g g G G a a t t e e ( ( H H 3 3 ) )
To lock or unlock the swing gate, use
the power door lock switch or the
Remote Keyless Entry transmitter.
To open the swing gate, pull the door
handle and open the swing gate
slightly. The swing gate will continue
opening automatically.
S S e e e e t t h h e e F F e e a a t t u u r r e e s s a a n n d d C C o o n n t t r r o o l l s s s s e e c c t t i i o o n n o o f f y y o o u u r r
O O w w n n e e r r M M a a n n u u a a l l . .
T T a a i i l l g g a a t t e e ( ( H H 3 3 T T ) )
To open tailgate, lift up on tailgate
handle and lower downward.
S S e e e e t t h h e e F F e e a a t t u u r r e e s s a a n n d d C C o o n n t t r r o o l l s s s s e e c c t t i i o o n n o o f f y y o o u u r r
O O w w n n e e r r M M a a n n u u a a l l . .
C C a a r r g g o o M M a a n n a a g g e e m m e e n n t t S S y y s s t t e e m m
( ( H H 3 3 T T ) )
5/14/08
Your vehicle contains a cargo
management system located in the
bed of the truck. The system contains
three rails located on the front and
sides of the bed.
The system has four adjustable cargo
tie-downs that can be placed on the
upper and lower slides of the rail. To
adjust a tie-down, pull the locator
pin out and move the tie-down to
another location making sure the
locator pin lines up with a locator
hole on the rail. The tie-down pin
may not be installed correctly if the
pin does not line up; turn it over and
reinstall. The tie-down will not move
when the pin is completely installed.
The maximum load for each rail is
500 lbs (227 kg).
The rails are notched at each end
which allows the tie-downs to be
removed and placed on another rail.
To remove, pull the locator pin out and
slide the tie-down to the end of the
rail and pull back.
To remove the system, loosen the
toggle bolts on each rail until they
can be removed from the bed of the
truck. To replace the system, place
the toggle bolts and rails into their
original locations and tighten them to
a torque setting of 12.5 ft-lbs (17N·m).
S S e e e e t t h h e e F F e e a a t t u u r r e e s s a a n n d d C C o o n n t t r r o o l l s s s s e e c c t t i i o o n n o o f f y y o o u u r r
O O w w n n e e r r M M a a n n u u a a l l . .
10:02 AM Page 14