Test Mode - Pioneer DEH-P690UB/XN/UC Service Manual

1

6.5 TEST MODE

- Implemented functions
TEST1 command
A
TEST2 command
TEST3 command
TEST4 command
TEST0 command
Indication of system microcomputer Ver
Indication of TCC firmware Ver
To enter the TCC firmware UpDate mode:
→Set this mode and insert a USB device having the UpDate program to start rewriting the device.
* If you carry out the TEST 3 command with the USB device inserted, a correct result is not displayed.
B
Confirmation on connection mode (mass storage class connection)
→Set this mode and insert a USB device. Then, the connection mode is displayed.
* Do not insert a USB device having the UpDate program.
* If you carry out the TEST 4 command with the USB device inserted, a correct result is not displayed.
Be sure to insert a USB device when "DeviceIn" is being displayed.
C
Enter the TEST1 command
Indication of system
microcomputer Ver
Enter the TEST0 command
D
- Indications
Indication of system microcomputer Ver
E
Indication of TCC firmware Ver
TCC firmware VerUp is getting ready.
TCC firmware VerUp is started.
TCC firmware VerUp is completed.
Confirmation on connection mode is
getting ready.
Now connecting
Indication of connection mode
F
56
1
2
Right key
Left key
LIST key
DISP key
BAND/ESC key
Normal connection
Activate the test mode
[EQ] + [DISP]
In the test mode
Enter the TEST2 command Enter the TEST3 command
Indication of TCC TCC firmware VerUp
firmware Ver is getting ready.
Insert a USB device
Enter the TEST0 command
TCC firmware VerUp
Passage of time : For about
several tens of seconds
TCC firmware VerUp
V e r * . * *
V e r * . * *
MIN SEC SEC
R E A D Y 0 0 0
Displays 0:00 to 3:00 (in increments of minutes and seconds)
U P D T 0 0 0
Displays 0:00 to 3:00 (in increments of minutes and seconds)
C O M P L E T E
* The time increment stops when it reaches 3:00.
D e v i c e I n
C o n n e c t
M S C
When a device supporting mass storage class is connected:
H I D
When iPod is connected:
DEH-P690UB/XN/UC
2
3
Enter the TEST4 command
Indication of connection
mode is getting ready.
Insert a USB device
for updating for confirmation
Now connecting
is started.
Passage of time : For about
several tens of seconds
Indication of
is completed. connection mode
Enter the TEST0 command
Reset start
3
4
4