PIN CONNECTOR
Pin
Signal
1
Red
2
Green
3
Blue
4
GND
5
GND
6
GND - Red
7
GND - Green
8
GND - Blue
9
+5Vdc (optional)
10
GND - H.Sync
11
GND - V.Sync
12
Bi-directional Data (SDA)
13
Horizontal Sync
14
Vertical Sync (VCLK)
15
Data Clock (SCL)
CAUTIONS FOR ADJUSTMENT AND REPAIR
• Degaussing is always required when adjusting purity or convergence.
• The white balance adjustment has been done by a color analyzer in factroy. The adjustment procedure,
described in the service manual is made by a visual check.
• Allow 20 minutes warm-up time for the display before checking or adjusting only electrical
specification or function.
• Reform the leadwire after any repair work.
Caution For Servicing
• In case of servicing or replacing CRT, high voltage sometimes remains in the anode of the CRT. Completely
discharge high voltage before servicing or replacing CRT to prevent a shock to the serviceman.
1
6
10
15
Arrangement of 15-pin D-sub connector
8
OPERATION AND ADJUSTMENT
Control Panel
•
Increase the value of any selected function.
•
While the OSD screen is off, you can adjust the screen
brightness according to each situation.
•
Decrease the value of any selected function.
•
Turns the OSD window on and off.
•
Move curosr to the previous function on the OSD window.
•
Move curosr to the next function on the OSD window.
9